Rittal 4055.710, Руководство по эксплуатации

Страница: 9 / 20

Rittal stationary busbar cutting unit CW 120-S We reserve the right to make technical modifications. 9
7 Commissioning
EN

Connect the hydraulic hose to the hydraulic connection (fig. 1, 3) and the elec-
trical control cable to the electrical connection (fig. 1, 2) of the unit.

Then insert the supply cable of the foot-operated switch in the 4-pole connec-
tor (fig. 1, 10).

Before the first use, the sealing screw plug (black) at the tank opening must be
replaced with the air permeable ventilation screw (orange) so that air can flow
into the oil tank during work.
Fig. 3: Replacing the screw plug or ventilation screw (example illustration)

Turn the mains switch of the hydraulic pump to the "I" position to place the
pump in ready mode.
Note:
Rittal recommends that the unit is fastened using the four holes in
the frame on a worktable or workbench.
Caution!
If the unit is operated with a non-approved pump, there is
risk of injury caused by bursting components of the hydraulic
circuit.

Ensure that only the electro-hydraulic pump, in conjunc-
tion with the unit, as specified in the technical specifica-
tions is deployed.
Note:
There is risk of hydraulic oil escaping in the event of a defective valve
or when the hydraulic hose is disconnected under pressure.

Ensure that the hydraulic system is pressure-free before discon-
necting or reinserting the hydraulic hose.
Note:
To prevent hydraulic oil from escaping, the sealing screw plug must
be reinserted in the tank opening for subsequent transport of the
unit.
Screw the sealing screw plug into the thread at the front of the elec-
tro-hydraulic pump to ensure quick and safe access when required.
Note:
Observe the details in the operating instructions of the electro-hy-
draulic pump.