Rittal 4055.710, Руководство по эксплуатации

Страница: 13 / 20

Rittal stationary busbar cutting unit CW 120-S We reserve the right to make technical modifications. 13
10 Maintenance and inspection
EN
Fig. 7: Loosen the fastening screws

Now loosen the two M8 screws (5) on the side of the cutter bar.

Before removing the screws, secure the blade so it cannot fall.
Fig. 8: Removing the blade

Finally, remove the blade at the bottom of the cutting unit (6). Take care, the
blade is sharp.
Installing the new blade:

Insert the new blade from below and push upwards to the cutter bar.

Screw in the two M8 screws (5) from the side with 15 – 20 Nm torque.

Finally, screw on the retainers (3) and the protective inspection window (4), and
reconnect the hydraulic hose.
10 Maintenance and inspection
The user is obliged to maintain and service the busbar cutting unit in accordance
with the details in the operating instructions and in accordance with the country-
specific standards and regulations.
The maintenance intervals are classified in accordance with the recommended
frequency.