qtm9322b.pm5
For assistance, call RITRON at 1-800-872-1872, or go to < http://www.ritron.com >
Page 8
RECORDING VOICE PHRASES FOR YOUR SWITCH CONDITIONS
PLAYING BACK THE OPEN AND CLOSED VOICE PHRASES
FOR YOUR SWITCH CONDITIONS
What is the purpose of Recording Voice Phrases?
Recording customized voice phrases gives Quick Talk
messages unmistakable meaning and significance. The
standard factory prerecorded messages of "Switch Open"
and "Switch Closed" require the listener to know how the
switch works and what it does. However, when a user
hears a custom message such as "Water pump three
running hot", the meaning is clear.
Do I need to program Voice Phrases? If the factory-
recorded messages "Switch Open" and "Switch Closed"
suit your application, you may skip this section.
Your recorded voice message will sound only as good as
the telephone set you use. If your message has the audio
too low, record it again, speaking louder. If your message
is distorted, record it again, speaking softer. If you are
dissatisfied with the audio quality, try a different telephone
set.
When the Quick Talk is transmitting, it draws maximum
power from the battery, and can also interfere with other
transmissions. Therefore, when you record a voice phrase,
hang up when you are finished speaking. Otherwise, the
Quick Talk transmitter will be on for the full eight seconds,
regardless of the actual message length.
To Record Your Switch Open Condition Phrase
a. Pick up the telephone receiver, wait for the beep
and dial "311".
Quick Talk sounds three short tones to prompt you
to begin speaking . . .
b. Record a phrase no longer than eight seconds,
describing the open condition of your switch.
Example: "Pump motor temperature OK".
c. Hang up the telephone when you complete your
phrase.
d. Pick up the telephone and dial "411". Your phrase
will be played back through the telephone receiver.
e. Return to Step a above and record again if you are
not pleased with the results.
To Record Your Switch CLOSED Condition Phrase
a. Pick up the telephone receiver, wait for the beep
and dial "312".
Quick Talk sounds three tones to prompt you to
begin speaking . . .
b. Record a phrase no longer than eight seconds,
describing the closed condition of your switch.
Example: "Pump motor over temperature".
c. Hang up the telephone when you complete your
phrase.
d. Pick up the telephone and dial "412". Your phrase
will be played back through the telephone receiver.
e. Return to Step a above and record again if you are
not pleased with the results.
To Play Back the Switch Open Condition Phrase
a. Pick up the telephone.
b. After the tone, dial "411". Quick Talk plays the
Switch Open condition phrase.
Example: "Pump motor temperature OK".
c. Wait for the confirmation beep, then hang up the
telephone, or continue programming.
To Play Back the Switch Closed Condition Phrase
a. Pick up the telephone.
b. After the tone, dial "412". Quick Talk plays the
Switch Closed condition phrase.
Example: "Pump motor running hot".
c. Wait for the confirmation beep, then hang up the
telephone, or continue programming.
