7 Series OUTPOST
®
Wireless Callbox
GateGuard
®
Application
Have questions?
Call 800-USA-1-USA
(800-872-1872) or visit our website at
www.ritron.com
O
PTIONAL
G
ATE
G
UARD
®
S
ETTING
/F
EATURES
(C
ONTINUED
)
..........................
Send Call Tone...................................................... (PC or FP)
The Factory Default setting has the Call Tone feature
ON
(
refer to “H
OW TO
F
IELD
P
ROGRAM
S
INGLE
-D
IGIT
R
ADIO
F
EATURE
C
ODES
” on page
14)
. The callbox can be programmed to
transmit a Call Tone if the Reset Time has expired and the
ON/PTT
button is pressed. This will alert system users that
the call is originating from the callbox.
Ring Tone .........................................................................(PC)
This will sound an alert tone on the callbox speaker, similar to
a telephone ring tone, whenever the correct 2-tone code has
been successfully decoded. This feature is used to alert the
Callbox user that the gate is being
opened
or
closed
. Ring
Tone is enabled from the factory.
GateGuard
®
– Toggle ........................................... (PC or FP)
Will alternately open and close the Switch Output when it
receives a unique 2-Tone code. After the 2-tone decode
(receive) code is received the callbox will transmit a single
beep if the switch has been
opened
and a double beep if the
switch has been
closed
. The switch will open when the
callbox turns off if it is programmed for Automatic Turn-Off.
GateGuard
®
On Code / Off Code ....................................(PC)
This operation allows programming of separate
ON
and
OFF
2-tone decode (receive) codes. The OUTPOST
®
will
CLOSE
the Switch Output upon receiving the
ON
code, and
OPEN
the
Switch Output upon receiving the
OFF
code.
When reading out the radio programming as described in the
“H
OW TO
R
EADOUT
C
URRENT
R
ADIO
F
REQUENCY
&
T
ONE
C
ODES
”
section, the
ON
code will be displayed.
Sensor/Contact Closure Input
The Sensor Input will detect a logic level and transmit an Alert
tone when a change in logic level is detected. Separate alert
tones are used for
OPEN
(logic level high) tone and
CLOSED
(logic level low) tone.
Busy Channel TX Inhibit ...................................... (PC or FP)
This will not allow you to transmit when another user is
already transmitting on your radio frequency, even if they are
using a different tone code. The radio will beep a series of
long, low tones (like a busy signal) while the
ON/PTT
button is
held down.
29
