3.2
Readout Current Frequency, Tone and Selective Signaling Codes
1. Loosen the (4) captive screws in the front corners of the case. These screws are captive to the housing; to
prevent damaging them,
DO NOT
remove the screws from the housing.
. Separate the case front from the case back, leaving the RPS-1A power supply connected to the radio.
2
3. Press and release the
PROGRAM
button (See
LPA-Series receiver assembly
on page 2 for location). The
radio will immediately begin to display a series of digits; with each digit separated by a hyphen.
4. Write down the all the digits. The first two digits indicate the frequency code and the next two digits the tone
code;
see
Table 1
and
Table 2
on page 16.
In this example an LPA-U450 is programmed to operate on the
“Brown Dot” frequency of 464.500 MHz (Frequency code “04”) with 100.0 Hz tone (Tone code “12”).
FREQUENCY CODE
TONE CODE
5. If a 5
th
digit is displayed, the LPA receiver has been programmed for DQC and the last three digits indicate the
DQC code;
see
Table 3
on
page 16.
In this example an LPA-U450 was programmed to operate on the
“Brown Dot” frequency of 464.500 MHz (Frequency code “04”) with a DQC code of “723”.
FREQUENCY CODE
DQC CODE
6. If more than 5 digits are displayed, the radio has been programmed for Selective Signaling Decode. The
frequency and tone codes will be displayed, followed by a “C”, then the radio will display either the 2-digit, 2-
Tone paging code (
see
Table 4
on 16
) or the 3-7 digit Selcall code
.
In this example an LPA-U450 was
programmed to operate on the “Brown Dot” frequency of 464.500 MHz (Frequency code “04”) with 100.0 Hz
tone (Tone code “12”) and 2-tone paging decode frequencies of 330.5 Hz and 569.1 Hz (2-Tone code “91”)
7. If the LPA-Series receiver
is PC programmed with any frequency not listed in
Table 1
on page 16, the radio
will display a code "99" for the frequency code. The PC programmer will be required to readout the radios
equency programming.
fr
FREQUENCY CODE
TONE CODE
PAGING CODE
8. Normal radio operation resumes after the programming information has been displayed.
Section 3
Programming
12
Содержание LPA-V150
Страница 2: ......
