Section 3
Programming
20
3.6
Program Loudmouth
®
Volume
The wireless speaker can be field programmed for any volume level between 05-99% by entering the volume level as a 2-digit
code. Field programming Speaker Volume Level sets both the voice and the pre-announce tone volume levels. The PC
programmer is required for independent programming of the voice and the pre-announce tone volume.
In our example we will program an LM-U450 for 25% Speaker Volume Level. The Loudmouth
®
is set from the factory with a
50% volume setting
.
1.
Refer to
Section 1.5 - Determine the volume setting
and write down the desired volume.
2.
Press and
HOLD
the
PROGRAM
button (See
Loudmouth
®
receiver assembly
on page 2 for location).
A "P" will appear on the program display as you enter program mode and the radio will beep rapidly.
3.
Release the
PROGRAM
button after the beeping has stopped. The radio will emit a triple beep
indicating that the radio is in program mode and a hyphen will appear on the program display.
4.
Scroll to the character “U” by clicking the
PROGRAM
button until the program display shows the
correct character.
Pause
—the radio will sound a low tone and show a hyphen across the center of the
display to indicate that it is ready to accept the first digit of the volume setting.
5.
Enter the 1
st
digit of the volume setting by clicking the
PROGRAM
button until the program display
shows the desired number.
Pause
—the radio will sound a low tone and show a hyphen across the
center of the display to indicate that it is ready to accept the next digit.
6.
Enter the 2
nd
digit of the volume setting by clicking the
PROGRAM
button until the program display
shows the desired number.
Pause
—the radio sounds a low tone and will show a hyphen across the
center of the display to indicate that it is ready to accept the next digit.
7.
Press and release the
ENTER
button to save your programming. A triple beep will sound to indicate
that programming was successful and a hyphen will appear on the program display. The radio is now
ready for another program entry.
NOTE:
An error tone will sound if you attempt to save an incorrect code, an "E" will appear on the
display. Check the digits you are attempting to enter, then re-enter.
8.
Once you have made your final program entry, press the
ENTER
button a final time to exit
programming mode. The Program display will be blank and the radio will be ready for use. The
Loudmouth
®
will exit program mode automatically after 30 seconds if no program entries are
attempted.
IMPORTANT NOTE:
Volume setting below 10% are entered as a 2-digit code with a fir
st digit “0”.
Checking the Current Volume Setting
To readout the current volume setting, follow the instructions above and enter a volume setting
code “00”. When you press the
ENTER
button the radio will immediately begin to display the 2-
digit volume setting; with each digit separated by a hyphen.
25
V
OL
UM
E
L
E
V
E
L
