Ritmo FLOW HD-PRO, Руководство по эксплуатации

Страница: 10 / 126

10
EN
Operating Instructions
General Safety Information
CAUTION! Read all the instructions. Errors in
observing the following instructions can result
in electrical shock, fire and/or serious injuries.
The term “electrical tools” used below, refers
to mains- operated electrical tools (with a
mains cable)
and to battery-operated electrical tools
(without a mains cable).
KEEP THESE INSTRUCTIONS IN A SAFE
PLACE.
Explanations for utilized symbols
Observe operating manual
Danger of explosion
Danger of fire
Hot surface
The device
· has been designed and tested in accordance
with EN 60335-1 in connection with EN 60332-
2-45.
· is CE certificated
· has left the plant in perfect condition as far as
safety is concerned.
In order to maintain this state, it is necessary
to observe the contents of this safety
information
when handling the device
(transportation, storage, installation,
commissioning, operation, servicing, de-
commissioning) as well as the
rating plates, labelling and safety information
attached to the device, otherwise it could
endanger persons and damage the device
itself as well as other equipment.
This safety information applies in the Federal
Republic of Germany. The relevant national
rules and regulations must be observed when
it is used in other states/countries. The
generally
valid safety and accident
prevention regulations must be observed in
addition to the references in this Manual.
If the information in this safety information
does not suffice, then you can contact the
manufacturer at any time at the indicated
address.
Please check the packaging and file a
complaint
with the forwarding agent immediately in the case
of any damages.
Please examine the device prior to commission-
ing to ensure that the device has no damages
of any kind. In the event of doubt, please ask a
qualified electrician for advice or contact the ad-
dress shown below.
If you assume that a danger-free operation
is no longer possible, then take the device
out of operation and secure it from being restarted
unintentionally.
One must assume that a danger-free operation is
no longer possible
· if the device or the connection lead shows vis-
ible damages,
· if the device no longer functions,
· if it was stored under detrimental conditions,
· after severe demands due to transportation.
Workplace
Keep your working area clean and tidy. Disorderly
and non-illuminated working areas can result in
accidents.
Keep children and other people away from the
electrical tools while in use. You can lose control
of the device if you are distracted.
Use the device only for its intended use (see
below).
Do not reach into the flow of hot air. Touch-
ing the jet or the protective pipe can result
in burns when it is hot.
A fire can develop if the unit is not handled
carefully.
Caution when using the device near flammable
materials. Do not direct towards one and
the same point for an extended period of
time.
Heat can be conveyed to flammable materials,
which are covered.
Never work with the device in surroundings
that could be explosive, or in which
flammable liquids, gases or dust can be found.
Electrical tools generate sparks, which can
ignite the dust or the fumes.
The connection lead may not come into
contact with hot parts.
Place on the stand and allow to cool off after use,
before it is packed away.