ritm Contact RC-1L ver. 2, Техническое описание

Страница: 5 / 8

5
7. Button designation
Button Pressing duration time Operation mode
1 At least 2 seconds Alarm transmitting.
2 At least 2 seconds
Mode of adding the radio channel receiver
“RDK-L” to the radio system.
8. Setting-up procedures
1. Open the enclosure.
2. If necessary, connect an additional wired panic button to the terminals 7 .
3. Install the battery CR123A to the connectors 5, 6 .
4. Switch the radio channel receiver “RDK-L” intended to be used with the button to
the mode of adding devices (see the receiver operating manual).
5. Switch the panic button to the mode for adding to the receiver radio system (see
section 8).
6. Press the build-in panic button 1 and ensure that the alarm is delivered to the
receiver (see the section 7).
For more details about successful adding the button to the receiver radio system and on
alarm transmission, use the radio channel receiver RDK-L configuration software.
Detailed information about interoperation with the radio channel receiver RDK-L see in
the Receiver operating manual available on the official website www.ritm.ru/en.
9. Maintenance
On a regular basis but at least twice a year check safety of contacts and if necessary
dress bonding pads.
Change battery as and when necessary.
10. Safety measures
All works related to installation, configuration and maintenance of the panic button
should be performed in accordance with the Electrical installation code and by qualified
personnel.
The radio channel panic button is a safe device, the maximum power supply voltage
level is 3 V.
11. Transportation and storage
The panic button should be transported in a package, in closed vehicles. Storage areas
should be free from current-conducting dust, acid and alkali fumes as well as active gases
able to corrode isolation.