RITE-HITE FLASHFOLD 1390, Руководство пользователя

Страница: 4 / 20

5. Slide curtain guides into the top of the header guides.
6. Loosen the 1/4” [6] bolts and nuts on the container,
Figure 4.1.
7. Slide the “T” nuts into the groove on the header guides
and place flush with the bottom of the curtain container
and tighten all bolts. In special ordered situations the
curtain container may need to be mounted some pre-
determined distance of the floor,
Figures 4.2 & 4.3.
8. Locate the mounting brackets supplied in the parts box,
and assemble brackets to the header guides with the
required 1/4-20 [6] bolts and “T” nuts,
Figure 4.4.
9. Attach the belting pressure plate to the idle belt
attachment bracket with the (2) 1/4-20 x 3/4” [6x19] bolts
and lock washers provided,
Figure 4.5. Repeat on non-
drive side.
10. Install idle belt attachment bracket on the inside of the
drive header guide flush with the bottom, using two 1/4-20
x 3/4” [6x19] bolts and “T” nuts,
Figure 6.
11. Tip both header guides to stand unit up.
HEADER GUIDE INSTALLATION
1. Locate the header and position in front of the machine.
Determine drive and non-drive side,
Figure 6.1.
2. Locate the drive (shorter w/2 loops) belt and fasten to the
drive side of the header by removing the center pin on the
bolt, looping belt through and tightening nut.
3. Locate the idle (longer) belt and route through the header
so 2’ [610] hangs out the drive side and the rest out the
non-drive side.
NOTE: To ease belting installation, elevate one end
of the header so the belt slides downhill.
4. Set blocks onto the curtain container frame so the header
can rest on them,
Figure 5.2.
4 PUB. NO. 1390E APRIL 2014
FLASHFOLD ™ MODEL 1390
FRAME INSTALLATION
Pre-Installed
1/4” [6] Hex
Bolts with T-Nuts
Slide Header Guide Over T-Nuts
Header Guides Flush with
Bottom of Curtain
Container Unless Specified
Attach belting to idle belting
pressure plate on drive side
Single Outside Floor
Mount Bracket
Floor Mount Bracket for Both
Sides of Header Guides
Brackets may be Turned
90° for Mounting to Wall
or Weld Unit
4.1
4.4
4.2
4.5
4.3