D.
Electrical Connection
(Optional) –
In many areas, supplemental heat is required, it is easiest to run the
electrical line at the same time you lay the waterline for your fountain. Electrical connections should be installed
under the unit.
WARNING: ANY ELECTRICAL SERVICE MUST BE INSTALLED AND MAINTAINED BY A
QUALIFIED ELECTRICIAN.
E.
Mounting Platform –
A concrete platform should be provided for all fountains. It should be at least 4” thick
and large enough to accommodate fountain. An additional 4” high step 18” out from each side of the unit will
protect the unit from manure handling equipment, as well as discouraging animals from defecating in the
fountain. Extending the platform provides animals a place to stand while drinking, consider the size of your
animals when determining the dimensions of your platform. Slope the platform away from the fountain for
drainage. A rough broom finish on the concrete surface provides better footing for animals.
F.
Preparing the Bottom -
Apply the foam weather stripping to
the bottom of the unit, along the outside edge of the fountain.
G.
Hold-Downs
- The 100, 150, 150S, and 300 fountains are
provided with four built-in hold-downs, and the 1000 fountain is
provided with six built-in hold-downs to anchor your unit securely to
the platform. Use of 3/8” x 5” stainless steel expansion anchor bolts
(not included) are recommended for concrete installations. Anchor
bolts are available from Ritchie in a two pack, part # 16555. Fender
washers are supplied for use with anchors.
H.
Assemble Valve -
The 100, 150, and 150S fountains come
with the valve already assembled and ready for use. Skip to the next
step for those units.
1.
Insert valve rubber into the valve rubber retainer.
2.
Attach float arm to float as shown in diagram. The
raised emboss on top of float should be orientated as
shown.
3.
Screw thumb screw into cam arm. To adjust water
level, tighten thumb screw to lower, loosen thumb
screw to raise.
4.
Insert the valve rubber retainer into the valve body
with the valve rubber up. Align the cam arm to the
valve body and insert first pin.
5.
Align the float arm and attached float to the cam arm
and insert second pin.
Valve Rubber
WaterMatic Series Instruction Manual
2
August 13, 2022
