Riso CV1860 Series, Техническое руководство, Страница: 85 / 243

7 - 6 CZ80 / CV860 Rev. .0
CHAPTER 7: PAPER EJECTION SECTION
Paper ejection motor FG sensor
4. Paper ejection motor FG sensor
REMOVAL
) Turn OFF the machine power, and remove following parts.
Paper ejection cover (M3x6 screws; 2 pcs)
Suction unit (M3x6 screws; 2 pcs)
2) Detach the left and right Paper ejection wings. (Thumb screws; each)
3) Unhook the Timing belt from the motor.
4) Remove the Driven shaft assembly.
5) Detach the Suction face cover. (M3x6 screws; 4 pcs)
6) Unplug the wire harness connector of the Paper ejection motor.
7) Remove the mounting screws, and detach the Paper ejection motor. (M3x5 screws; 2 pcs)
8) Unplug the wire harness connector from the Paper ejection sensor, and detach the sensor.
5. Suction belt
REMOVAL
) Turn OFF the machine power, and remove following parts.
Paper ejection cover (M3x6 screws; 2 pcs)
Suction unit (M3x6 screws; 2 pcs)
2) Detach the left and right Paper ejection wings. (Thumb screws; each)
3) Unhook the Timing belt from the motor.
4) Remove the Driven shaft assembly.
5) Detach the Suction face cover. (M3x6 screws; 4 pcs)
6) Remove the E-ring and Metal bushing from the Driving shaft and remove the Driving shaft. (4mm
dia. E-ring; pc)
7) Remove the Suction face cover completely from the Suction unit with the Suction belts attached.
8) Slide the Suction belts off from the Suction face cover.
Precaution in Removal
) Pay caution not to scratch the Suction belts against the sharp edges on the Suction face cover to
prevent damage on the belts.
[ Refer to the three photographs on the next page.]
RISO Inc. Technical Services & Support US.RISO.COM