V1.1 2018-10-9
www.risinghf.com
RHF2S208 User Manual
RisingHF
35
[2018-08-03 02:14:38]->[ltediagnosis: OK, 460042462508255]
[2018-08-03 02:14:38]->[ltediagnosis: lte diagnosis done]
APN configuration
Normally, the APN configuration for most of the operators is included. But users could re-configure the
APN if needed. Please use the comand “addapn” to add a new APN configuration. Use “addapn -h” to
get help.
rxhf@rhf2s208:~ $ addapn -h
Usage: addapn [options]
Options:
--help
Show this help
--carrier <CARRIER>
Set carrier name
--mcc <MCC>
Set carrier mcc
--mnc <MNC>
Set carrier mnc
--apn <APN>
Set carrier apn
--user <USER>
Set apn user
--pwd <PWD>
Set apn pwd
Examples:
addapn --carrier CARRIER --mcc MCC --mnc MNC --apn APN --user USER --pwd PWD
addapn --carrier CARRIER --mcc MCC --mnc MNC --apn APN
6.1.2 10/100m Ethernet
When you connect the gateway to the ethernet with wired cable, a eth0 interface is found. The gateway
will get an ip in the lan. Please use ifconfig to check the ip. You could also use ping command to check
the connection quality.
Figure 6-1 Eth0 interface
6.1.3 Networking priority choice
RHF2S208 could connect to the cloud server with wireless 4G LTE networking or wired 10/100m
ethernet networking. And you could set the priority of the two modes on the web-based utility. The
system would be reboot after you reconfigure the priority of the networking for backhaul, then you could
use command route to check if the priority is changed or not.
