V1.1 2018-10-9
www.risinghf.com
RHF2S208 User Manual
RisingHF
31
5.2.1 Register RHF2S208 Gateway
1) Get MAC address, which is in format xx:xx:xx:xx:xx:xx. MAC address is sticky on the side of the
RHF2S208 device. You could also use command ifconfig to get the MAC address or find it on
the web-based utility.
rxhf@rhf2s208:~$ ifconfig
===========================================================================
eth0: flags=4099<UP,BROADCAST,MULTICAST> mtu 1500
ether
b8:27:eb:80:af:ac
txqueuelen 1000 (Ethernet)
RX packets 0 bytes 0 (0.0 B)
RX errors 0 dropped 0 overruns 0 frame 0
TX packets 0 bytes 0 (0.0 B)
TX errors 0 dropped 0 overruns 0 carrier 0 collisions 0
Figure 5-2 Mac addr shown on web-based utility
2) Access
register account, log in directly if you have already gotten one.
3) Click Dashboard -> Gateways -> Add Gateway, choose RHF2S208
4) Radio front-end configuration. Match the device type. Available options:
a) 868/915 MHz (SX1257)
b) 434/470/780 MHz (SX1255)
c) Note: RHF2S208-780MHz gateway need choose "868/915 MHz (SX1257)"
5) Scroll down, fill in MAC address, and set gateway location information.
6) Click "Register RisingHF RHF2S208 Gateway" finish register
7) Click "Go to the gateway detail page" or click "gateway xx:xx:xx:xx:xx:xx" from plane at the left
to enter gateway configuration page.
8) According to the gateway frequency band to choose a band. Contact
if
you need help.
9) Register gateway finish.
10) Connect Ethernet cable, power up RHF2S208.
11) Log in to the gateway and start Loriot service and start test.
5.2.2 Start Loriot Service
Set auto start:
sudo systemctl enable loriot-gw
Start:
sudo systemctl start loriot-gw
Stop:
sudo systemctl stop loriot-gw
