Risecomm ZNLY-201, Руководство пользователя

Страница: 12 / 16

7
Plug the power cord into the power port on the Smart Router.
3. Restart Power
Plug the other end of the power cord into an electrical wall outlet, and then your network
cables are connected. You are ready to start your network. It is important that you start
your network in the correct sequence (first power on the Smart Router, and after it finishes
starting up, power on the computer).
CAUTION:
The operating distance or range of your wireless connection can vary
significantly depending on the physical placement of your router. For example, the
thickness and number of walls the wireless signal passes through can limit the range. For
optimal wireless network performance, place your router in a suitable area for installation
(near an AC power outlet and the center of the area where your computers and other
devices operate.)
Getting Started
This part explains how to set up your router after you complete cabling as described in the
Connecting the Router and in the previous chapter.
Before you start the setup process, make sure the computers and devices in the network
have the settings described here.
Wire Network Setup Preparation
You need to set up your computer to use a static IP address, and change the IP addresses
so that it uses the same address range of the Smart Router. (The default IP Address of the
router is 192.168.8.18). Consult the documentation that came with your computer or
operating system for instructions about how to set a static IP address.
Here are the steps to set a static IP address on Windows 7.
» Click
Start
, click
Control Panel
, and then choose
Network and Internet
.
» Click
Network and Sharing Center
displays the Network and Sharing Center window.
» Click the
Local Area Connection
to begin configuring your static IP address.
» From the Local Area Connection Status window, click the
Details
button to see your
existing connection details (most likely DHCP). Click the
Close
button.
» Back at the Local Area Connection Status window, click the
Properties
button. It will
show you the Local Area Connection Properties dialog. Click on the
Internet Protocol
Version 4 (TCP/IPv4)
in the item box of the dialog window.
» Click the
Use the following IP address
radio button and enter the appropriate values
for your static IP address that is on the same range as the LAN IP Address on your router.
The IP Addresses on your network must be within the same range. Example: If the
router´s LAN IP Address is 192.168.8.18, make your IP Address 192.168.8.X where X =
2-99. Make sure that the number you choose is not in use on the network.
»
Click OK .
Other operating systems just locate the "Internet Protocol (TCP/IP)" set a Static IP
Address according to the above