2. The red indicator light keeps bright when charging. When fully charged the
red indicator light off and the green indicator light keeps bright.
Warning: Please only use equipped charger to charge the Lipo battery.
Lithium-Polymer(LiPo) batteries must not be placed in with household trash.
Please contact your environmental or waste agency or the supplier of your
model for local regulations and the location of your nearest LiPo battery
recycling center.
LiPo Battery Disposal & Recycling
Calibration instructions:
When the quadcopter takes off hovering can't be adjusted by trim and causes
difficultoperation, then please adjust the quadcopter according to below steps:
1. Pull out the power of quadcopter, power off the transmitter;
2. Power on the transmitter, push the throttle stick to utmost and then back to
lowest position.( see pic 1/2),then the transmitter is ready to code pairing.
3. Power on the quadcopter and put it on a level surface, about 3 seconds later,
you will hear "di,do,di ", and it shows code pairing successful.
4. It's not allowed to push the throttle stick
before adjustment. Operate the transmitter
stick forward and backward/ left and right to
the lower right corner (see pic 3), then
quadcopter gets a solid light and no more
flashing, it shows adjustment finished and
quadcopter is ready to fly.
Picture 1
Picture 2
Picture 3
Flying operation:
1. Power on transmitter,the LED indicator begins flashing. Push up throttle stick
to top end and then pull down to low end, the indicator gets a solid light. It
shows transmitter is ready for code pairing with receiver.
2. .Install the batteries to the battery box and power on the drone.
3. Put the quadcopter on the flat ground,when blue light stops flashing and is
stable, then the quadcopter is ready to fly.
5
