WARNINGS
Receiver Connections
Receiver Aerial
Servo Throws
Receiver Protection
Ensure that the servo and battery
connectors are firmly pushed
into the receiver.
Vibration may cause a poorly
fitted connector to fail during
flight.
Do not cut or bundle the
receiver’s aerial. Do not wrap
the aerial with servo wires
and always keep the aerial a
minimum of 20mm away from
metal and carbon components.
Cutting or bundling the aerial
with other components will
reduce the receiver’s sensitivity
and range.
Operate each servo over its
entire range of travel. Ensure that
each pushrod or linkage does
not bind.
A binding linkage can cause
damage to servos and lead to
higher current drain which will
reduce battery performance.
Ensure that the receiver is
adequately protected from
vibration by wrapping in foam
rubber. Always protect the
receiver from moisture and both
fuel and exhaust residue.
If the receiver is subjected to
vibration and shocks or excessive
moisture or exhaust residue,
there is a risk that it may
operate incorrectly and possibly
fail.
RUDDER
Channel 4
ELEVATOR
Channel 2
B/6
5
4
3
2
1
ELEVATOR
Channel 2
AILERON
Channel 1
B/6
5
4
3
2
1
RUDDER
Channel 4
ELEVATOR
Channel 2
B/6
5
4
3
2
1
ELEVATOR
Channel 2
AILERON
Channel 1
B/6
5
4
3
2
1
The Saturn X transmitter has a mixing switch that allows you to select a V-Tail mix -
where the elevator and rudder functions are mixed for V-Tail aircraft, or a Delta mix
- where the elevator and aileron functions are mixed for flying wings and deltas.
Simply connect the servos as show and move the mix switch to the appropriate
position.
V-Tail Mix
Delta Mix
Mixer
V-Tail
Delta
OFF
Mixer
V-Tail
Delta
OFF
Mixer
V-Tail
Delta
OFF
Mixer
V-Tail
Delta
OFF
Mixing
