Adjustment Procedures
The servo direction and centre position of each of the four channels can be
adjusted.
Servo Reversing:
Turn on the transmitter and the receiver. Check the direction of operation of
each servo. If a servo operates in the wrong direction, it can be reversed without
changing the linkage, by simply changing the position of the corresponding servo
reversing switch.
CH1 corresponds to CH1 (AILERON)
CH2 corresponds to CH2 (ELEVATOR)
CH3 corresponds to CH3 (THROTTLE)
CH4 corresponds to CH4 (RUDDER)
Note: If you have an electronic speed controller and motor connected to the
receiver and you need to reverse the throttle channel, you should turn off the
receiver and transmitter first, reverse the channel then, ensuring that the throttle
stick is in its low position, switch on the transmitter then the receiver.
Servo Trims:
To adjust the centre position of each primary control, simply move the
corresponding mechanical trim levers left / right or forwards / backwards
until the correct amount of adjustment has been made.
After making changes to the trim and servo reversing switches, check that no
pushrods or linkages bind through the full travel of the servos.
Reversing Switches
NORMAL
REVERSE
Elevator
Trim
Rudder
Trim
Aileron
Trim
Throttle
Trim
