Chapter 2 Ready, Setup, Go 23
CR500 Mid-Tower Case
Troubleshooting Your New CR500
The Front panel LED for Power and HDD activity does not lit.
The polarity of the LED cables matter, and they are not connected as they should
(inverted polarity), connect the positive cable marked as “+” to the right mother-
board “+” pin header, do the same for the negative, (refer to your MB manual to
identify the right pin headers.)
How to clean the Dust filters.
The CR500 comes with dust filters, and are meant to help keep the computer
components clean, blocking the dust from the outside, they are located across
several points
that could potentially be used as intake areas. (Fresh air intake)
- Slide in filters: usually located on the bottom of the case, this needs to be
gently pulled out, and use canned air to clean, once done just push it
back to its position.
- Front bezel Foam filter: to access this, just pull the bezel from the bottom.
Once detached, Use canned air to clean it and then reinstall it
Содержание CR500 MID
