20
Use Blenderm tape on the front of the hatch.
Sand the sides of the hatch to match the
fuselage.
In use, you gently bend the hatch up at the
center until the tongue releases at the rear and
open.
Balancing
The sea monkey should balance about 40% (3.2
inches) behind the leading edge of the wing.
The CG is important for an easy flying model.
If the CG is significantly behind this, add weight
or use a larger capacity 2S battery.
If the CG is forward of this, fly it first. If it needs
more up trim than you have, add weight to the tail
or use a smaller 2S battery.
Flying
Set the rudder and elevator so that they move ½
inch in either direction.
If you have dual rates use ½ inch on low rate and
1 inch on high rate.
This is a slow flyer. Full throttle is seldom used,
except when climbing steeply.
Flight speed is very slow, so takeoff and landing
speeds are almost nothing.
Always fly when the wind is calm. Any more than
about 5 mph wind is not fun.
Always take off into the wind.
Содержание Sea Monkey
Страница 4: ...4 5mm ESP foam parts ...
Страница 5: ...5 ...
