5. Install the Filter Cartridge
Open the Filter Housing lid counter-clockwise. Put the new filter cartridge into the cartridge
chamber and close the lid clockwise. Ensure black “O” ring is placed correctly inside housing.
6. Pre-Fill Check
Ensure the drain outlet is extended for future draining/access (Fig. A), check that the washer is in
the cap, then tighten. Check the stopper (Fig. B) on the bottom of the spa and the Drain Cap,
ensure both of them are closed tight. Fill the spa with water using a garden hose until reaching the
water level printed on both interior sides of the spa wall (Fig. C1 & C2).
7. Purge Air From Portable Control Unit
Turn on the Portable Control Unit and select the filter function; the air in the pump must be
released. Unscrew the Air Valve counter-clockwise and release the air until the water is coming
out, then screw the air valve clockwise tightly. Use a towel to dry off the pump.
(Fig. A)
Thermal Blanket
Place Thermal Blanket on water surface for
more efficient heating and improved heat
retention.
(Fig. B)
(Fig. C1)
(Fig. C2)
Press the Temperature Increase/Decrease Buttons to set an appropriate temperature.
Press the Heating Button to heat the water. Put on the lid while heating. Once the water
reaches the desired temperature you can enjoy your spa. Press the Jet Massage Button to
activate massage system. We suggest a temperature range between 98.6°
F-
102°
F (
37-
39
℃)
during the winter. The massage system will stop automatically after 15 minutes of
operation to reduce energy consumption. Re-activate the Jet Massage function by
pressing the Jet Massage Button again (See Part 7 for Control Functions).
Lock the Buckle
Push the square pad upwards to lock and downwards to unlock (Fig. A).
Part 4
USAGE
(Fig. A)
8
