2
Always
mount the extractor hood over the center of
the hob.
Ensure that the appliance is installed in a location
with good permanent ventilation.
When making the electrical connections, check that
o
the mains voltage and frequency corresponds to
the technical information shown on the rating
plate.
o
Electrical connection must be made in
accordance to local standards only. Check that
the voltage in your area is correct before
plugging in.
Use an
electrical connector with earth that is correct
for your location. The electrical connection of this
appliance must be connected to earth (w
here
applicable)
:
o
Green & Yellow = EARTH; Blue = NEUTRAL;
Brown =LIVE
Ducted mode:
o
Connect the extractor hood to the exhaust duct
through a pipe of minimum Ø125mm. Use the
shortest and straightest duct route possible.
o
Do not connect the extractor hood to exhaust
ducts carrying combustion fumes.
o
Arrange proper ventilation if the extractor hood
is used in conjunction with other appliances
which are not supplied by electrical power e.g.
gas burning appliances. The kitchen must have a
direct opening to the outside in order to allow
entry of fresh air.
Note:
The manufacturer accepts no responsibility for
complaints attributed to the design and layout of the
pipe work.
Do not flambé or grill with an open flame directly
under the extractor hood. Flames could be drawn up
into the hood by the suction and the grease filters
may catch fire.
Monitor cooking continuously as overheated oil
increases the risk of self-ignition.
Do not operate the extractor hood without a grease
filter.
It is important to clean and/or replace the filters at
appropriate intervals.
Grease deposits build-up increases the risk of fire.
Always disconnect the unit from the power supply
before carrying out any cleaning or maintenance work
on the hood.
Ensure that the power supply chord is free from any
heat source or sharp objects.
Multiple plugs and extension cables must not be used.
Overloading is dangerous and may cause a fire hazard.
Disposal
This appliance and its packaging are environmentally
friendly and recyclable. Please help us to care for the
environment by disposing the packaging in a proper
manner and recycling any old appliances.
Before disposing an old appliance, disconnect it from
the power supply and cut the power supply cord to
prevent hazards.
The manufacturer will not be held liable for any
damages resulting from improper installation nor
failure to adopt proper safety measures during
installation and operational use of the appliance.
Fig. 1
En
gl
ish
