Rinnai N-BW2, Руководство по установке, Страница: 11 / 20

Rinnai 11 Touch Wi-Fi Kit IM
4.2 SECURING THE WI-FI MODULE
With the supplied screws secure the Wi-Fi Module backing plate
to a truss within the ceiling or joist beneath the floor. Figure 3
shows the recommended orientation of the Wi-Fi Module backing
plate and Wi-Fi Module.
Figure 3. Mounting Wi-Fi Module
NOTE
We recommend mounting to backing plate once
configuration is complete. As once mounted,
removal may be difficult.
Rinnai Rinnai
Secure
screws
Backing
Plate
4.3 ELECTRICAL CONTROL WIRING
Use “Figure 4. Control Configuration” on page 12 to determine
the power requirements and control wiring configuration for your
system.
Once completed, with all power OFF to the system, connect the
Wi-Fi Module as shown in Figures 5, 6 or 7. Once wiring of the
system is complete the power should be turned
ON in the below
sequence:
1. 506 or 516 Zone Module (if connected)
2. Ducted Gas Heater, Evaporative Cooler or Add-On
3. N-PM1 Power Module (if connected)
4. Wi-Fi Module
NOTE
Every system must have at least one NC-3, NC-6
or NC-7 Master Controller. Other connected
devices may include NC-3, NC-6, NC-7 and NT-1.