Rinnai BEPH10DTWF, Руководство по эксплуатации и установке

Страница: 9 / 24

Rinnai 9 Electric Panel Heater OIM
CONNECTING THE POWER
Plug the heater into a power outlet and turn
the power outlet on. Once power is connected
the rising start up chime will sound and the power
indicator
6
will illuminate on the Digital LED display
B
to show the heater is now in standby mode.
OPERATION
1. Press the POWER button
1
on the control panel console
A
once to start heating operation, a second rising
chime will sound. The two digits
5
on the display panel will now show the programmed temperature setting.
The factory temperature setting for the heater is 21°C. If this is above that of the current room temperature
the red operation indicator
7
will illuminate and the heater will begin to heat the room.
2. To change the temperature setting press the MODE button
2
once. The °C (temperature) indicator
15
on
the display panel will flash.
NOTE
If after 5 seconds no buttons are pressed the °C indicator will stop flashing and the display will
revert back to the current operating setting. Simply press the MODE button to re-enter temperature
setting operation.
Press the ‘Up’
3
or ‘Down’
4
buttons to increase or decrease the temperature setting. The available temperature
setting range is from 5°C to 30°C.
3. To exit the temperature setting operation either press the MODE button
2
three times or wait 5 seconds. The
selected temperature will now be set and displayed.
If the selected temperature is above that of the current room temperature the red operation indicator
7
will
illuminate and the heater will begin to heat the room.
If the selected temperature is less than that of the current room temperature the red operation indicator
7
will go out and the heater will go into a standby state until the room temperature has fallen below the set
temperature, when the heater will then automatically switch on and heat the room.
NOTE
During the operation of any soft-touch button, the display of LCD reach maximum brightness.
when there is no operation after 30 seconds the Digital LED display will dim while the power
indicator 6
, the red operation indicator
7
and WiFi indicator (if active) keep minimum brightness.
4. To stop heater operation completely press POWER button
1
, the shutdown falling chime will sound, the
power indicator
6
will remain illuminated to show that the heater has returned to standby mode.
IMPORTANT
During the initial burning in period or after long periods of non use some light grey smoke or
smell may be experienced. This is normal and is caused by dust that may have settled on the
heating element. During this period the space being heated should be well ventilated.
18
B
1
2
3
4
5
A
6
7
15
ABOUT YOUR ELECTRIC PANEL HEATER