Rinnai BC-100V, Руководство по эксплуатации и установке, Страница: 8 / 20

Rinnai 8 HW_CF_DELUXE OIM
DELUXE BATHROOM WATER CONTROLLER (BC-100V)
Turning On
If the water controller is switched off (No digits displayed in the digital monitor window)
press the On/Off button once.
The On/Off and Transfer buttons illuminate to indicate that the hot water unit will be
ready to supply hot water once a hot water tap is opened.
Adjusting Temperature
Select the desired temperature using the Temperature or buttons until the
required temperature is displayed on the digital monitor.
To operate the hot water unit, open any hot water tap. This will automatically light the
burner providing hot water. The water heater ‘In Use’ indicator will illuminate on the
water controller(s).
Once the hot water is running, if the set temperature is either too hot or cold press the
Temperature or buttons until the desired temperature is reached.
NOTE
Whilst hot water outlets are open the set temperature may be lowered,
however it cannot then be raised above 43°C. In addition transfer of
'priority' between controllers is not possible� These are safety features�
If the water heater is turned ‘Off’ whilst hot water taps are open it can
not be turned back ‘On’ until all hot water taps have been closed�
CAUTION
Always check water temperature at the outlet before use� A parent or
carer should always check the temperature before a child is placed in
contact with hot water, see "Warning About Hot Water" on page 4�
Used to transfer control priority between the Water
Controllers. The controller with priority has command of
the hot water delivery temperature. This button is
illuminated when this controller has priority.
TRANSFER BUTTON
SPEAKER
Used to start and stop the Smartstart preheat unit (when
fitted), See Smartstart Operation on page 12.
This button is illuminated when the Smartstart preheater
(when fitted) is activated.
PREHEAT BUTTON
Indicates the selected hot water temperature.
WATER TEMPERATURE INDICATOR
Indicates that the Shower Saver / Bath Fill function has
been selected and that a shower is running or the bath
is filling.
SHOWER SAVER / BATH FILL INDICATOR
12 Hour AM / PM clock display.
Indicates how much water remains to flow for the
selected Shower Saver / Bath Fill volume, decreasing
while shower runs or bath fills.
In the event of a fault, error message codes will flash here.
CLOCK & REMAINING WATER
VOLUME INDICATOR
In Normal and Shower Saver / Bath Fill modes these
buttons are used to select the water temperature.
In 'Clock' mode these button are used to set the clock.
TEMPERATURE BUTTONS
Indicates Shower Saver / Bath Fill volume selected.
WATER LEVEL INDICATOR
Used to select Shower Saver / Bath Fill function. This
button is illuminated when the Shower Saver / Bath Fill
function is selected.
Used to select Shower Saver / Bath Fill volumes.
WATER VOLUME BUTTONS
Used to select the voice and audible tone options.
SOUND VOLUME BUTTON
Used to select clock setting mode.
CLOCK SETTING BUTTON
SHOWER SAVER / BATH FILL BUTTON
Used to switch the water heater on and off. This button
is illuminated when the hot water heating system is on.
ON/OFF BUTTON
Indicates that the water heater is in operation and
delivering hot water.
WATER HEATER 'In Use' INDICATOR
DIGITAL MONITOR
HOT HOT
COLD COLD
ON! ON!
WATER CONTROLLER OPERATION