2000559_B
3
3
1
2
2
Prepare the Producer III
Set up your printer (Everest)
Set up your printer (Prism)
Connect the Producer III cables (7100N, 8100N)
Connect the Producer III cables (7100, 8100)
Rimage Producer III
™
and Producer IIIN
™
Setup and Installation Guide
Copyright © 2007 Rimage Corporation
a. Connect the
power cord
from the
Producer III
to the power
outlet.
b. Connect a
network
cable
from the
Producer III
to a network
connection.
a. On the Producer III, open
the
front door
.
b. Cut the plastic
tie wrap
from the lift arm.
c. If you have a Producer
8100 or 8100N, remove
the
tape
from the disc
feed tray.
d. Remove the
shipping
foam
inserted above the
carousel.
e. Close the
front door.
Caution!
Do not cut
the belt or cable!
Important!
Keep all packaging materials.
a. Unpack the
Everest printer
. Refer to the
label on the Everest printer box.
b. Prepare your
Everest printer
.
i. Press the two
side
cover latches
.
ii. Lower the
side cover
.
iii. Open
latches 1, 2, and 3
as indicated by
the arrows.
iv. Remove the
plastic packing pieces
from inside the printer.
v. Install the
print ribbon
and
retransfer
ribbon
. Refer to the instruction label on
the side cover, or to the
Everest User
Guide
available at www.rimage.com/
support.html.
Navigate:
Printer Family >
Support - Everest > Documents tab.
Important!
Keep all packaging materials.
a. Unpack the
Prism printer
.
Refer to the label on the
Prism printer box.
b. Place the
printer
on the
Rimage Producer III so that
the plastic printer feet slide
into the slots on the printer
plate.
Important!
Keep all packaging materials.
Note:
The parallel port is not used.
OR
Note:
Connecting a network cable is necessary only if you plan to submit
orders over a network.
Note:
The 7100 has 2 FireWire cables, and the 8100 has 4 FireWire
cables.
OR
Before you begin:
This document describes how to set up your Producer III product. Products in
the Producer III family include the Producer 7100, Producer 7100N, Producer
8100, and Producer 8100N.
The term ‘Producer III’ is used throughout this document to refer to the
Producer 7100, Producer 7100N, Producer 8100, or Producer 8100N.
c. Place the
printer
on
the Producer III so
that the plastic printer
feet slide into the slots
on the printer plate.
Tie Wrap
Foam
d. Connect the
printer cable
from the
Producer III to the printer.
f. Connect the
power cord
from the
Producer III to the printer.
c. Connect the
USB
cable
from the
Producer III to the
printer.
d. Connect the
printer cable
from
the Producer III to
the printer.
e. Connect the
power
cord
from the
Producer III to the
printer.
a. Connect the
power cord
from the
Producer III
to the power
outlet.
c. Connect the
FireWire
cables
(Qty. 2 or 4) from
the Producer III to the
external control center.
b. Connect the
USB cable
from the Producer III to
the external control center.
f. Press the Prism
printer
power
switch
to the On
position.
e. Connect the
USB cable
from the
Producer III to the printer.
Slots
Printer Plate
Slots
Printer
Plate
Plastic Packing Pieces
Latch 1 Latch 2 Latch 3
