6
11.
Remove the screws from the access holes.
12.
Go to “Installing the Printhead,”
Installing the Printhead
This procedure should be done after removing the printhead. If you have not removed
the printhead, go to “Removing the Printhead” on page 3.
1.
Power off the printer.
2.
With the cable connectors facing up and placed toward the back of the printer,
slide the new printhead under the printhead pivot-arm assembly. See the figure
below.
3.
Plug in all of the cables to the printhead before installing the screws. Some
printheads have three connections while some printers may have only two cables.
This is not a problem, just connect the two cables as shown on page 5. (Middle and
right side as you face the printer from the front.)
Caution:
Handle the printhead with care to avoid damage to the printing elements. Do NOT
use any objects to prop or position the printhead in position.
