2004012_A
Page 2
Copyright © 2017 Rimage Corporation
Rimage Everest Encore Setup and Installation Guide
6
Install the Everest Printer Driver
7
Learn More
5
Install the Rimage Software
4
Attach the Cables
Power Cord
USB Cable
For instructions on how to set the print settings, as well as how to operate and
maintain the Everest Encore printer, refer to the
Rimage Everest Encore User
Guide
. The user guide is available at
www.rimage.com/support
.
For additional support and product information, go to
www.rimage.com/support
.
Before you can operate a standalone Everest printer or an AutoEverest
AutoPrinter, you must install the Rimage software. (The Everest printer driver is
installed in step 6.)
a.
Connect the
USB cable
to the rear of the printer.
b. Connect the other end of the
USB cable
to the computer’s USB port.
c. Connect the
power cord
to the rear of the printer.
d.
For now, leave the
power cord
disconnected from the power outlet.
If you are using the Everest as a
standalone
printer
, follow the instructions
below to attach the cables.
Note:
The Everest printer powers on when the power cord is connected
from the printer to the power outlet. You will power on the printer
during the printer driver installation in step 6.
Note:
While it is necessary to install Rimage software to operate the
Encore printer, any software can be used for printing, not just CD
Designer.
-
Important!
If you are installing the Everest Encore printer on an
autoloader or AutoPrinter, refer to your product’s setup and installation
guide for cabling instructions.
-
Important!
If your Everest printer was included with a Rimage embedded
autoloader (including Producer V or Catalyst), all Rimage software,
including the printer driver, is pre-installed on the embedded PC.
a.
Make sure that the
USB cable
is connected from the Everest printer
to your PC.
b. Power on the
Everest printer
.
•
For a standalone printer, connect the
power cord
from the
printer to the power outlet.
•
For an AutoEverest AutoPrinter, power on the
AutoPrinter
.
The Printer driver installs automatically.
a.
Insert the
Rimage CD Designer Software Suite disc
that shipped with the
printer into your computer’s disc drive.
b. If the installation does not start automatically, browse to the disc drive
on your computer and open the file named
setup.exe
.
c. Follow the prompts to install the
CD Designer software
.
Power Cord
USB Cable