2004012_A
Page 1
Copyright © 2017 Rimage Corporation
Rimage
®
Everest Encore
™
Setup and
Installation Guide
2
3
Before You Begin:
This guide provides the information needed to set up a standalone Everest Encore
printer. The instructions in this document are intended for people who are familiar with
hardware setup, software installation, and Windows operating systems. If you do not
understand the procedures in this document, ask your computer technician for help.
-
Important!
•
If your Everest printer is part of an autoloader system, including Producer V,
or Catalyst systems, refer to your autoloader’s setup and installation guide for
instructions on setting up the Everest printer.
•
If your Everest printer is part of an AutoPrinter, refer to the
Rimage AutoEverest
Setup and Installation Guide
.
•
Documents referenced in this procedure are available online at
www.rimage.com/support
.
•
Read all setup instructions thoroughly before you begin.
•
Save all packing boxes and packing materials for use if the printer ever needs to
be shipped.
Notes:
•
The terms “Everest” and “printer” are used throughout this document to refer
to the Everest Encore.
•
Unless otherwise indicated, all Windows navigation statements are Windows 10
paths. Other Windows operating systems’ navigation may differ slightly.
•
Your product may not look exactly like the product pictured.
#
Required tools:
Phillips screwdriver
Install the Print Ribbon
Install the Retransfer Ribbon
1
Prepare the Everest Printer
a.
Unpack the
Everest printer
. Refer to the
unpacking label on the printer box for
instructions.
b.
Set the
AC voltage switch
.
Note:
Follow the instructions on
the instruction card on the rear of
the printer.
c.
Move the
shipping screw
.
i.
On the rear of the Everest printer,
use a Phillips screwdriver to
remove the
shipping screw
from
the shipping position.
ii.
Insert the
shipping screw
into the
storage position.
Side Cover Latches
Latch 1
Latch 3
Latch 2
Shipping
Position
AC Voltage
Switch
Storage
Position
Instruction
Card
d.
Press the two
side
cover latches
.
e.
Lower the
side cover
.
Print Ribbon Carrier
a.
Grasp the handle and pull to remove the
print ribbon carrier
all the way out of the
printer.
b. Lay the
print ribbon carrier
on its back.
c. Wrap the
print ribbon
around the guide
rollers, as shown.
d. Snap the
supply roll
and
take-up roll
into
the print ribbon carrier.
e. Tighten the
print ribbon
by turning the
take-up roll clockwise.
f.
Insert the
print ribbon carrier
into the
printer.
Note:
Do not close the latches yet.
a.
Grasp the handle to slide the
retransfer
ribbon carrier
out of the printer.
b. Slide the
retransfer ribbon
under
the retransfer ribbon carrier.
Note:
The ribbon winds under
the supply roll, as shown.
c.
Snap the
supply roll
and
take-up roll
onto the carrier.
d. Tighten the
retransfer ribbon
by turning the takeup roller
counterclockwise.
e.
Slide the
retransfer
ribbon carrier
into the printer.
f.
Close
latches 1, 2, and 3
, as
indicated by the arrows.
g.
Close the printer
side cover
.
f.
Inside the printer, open
latches 1, 2,
and 3
as indicated by the arrows.
g. Remove the
plastic packing
pieces
from inside the printer.
Plastic Packing Pieces
Guide Rollers
Supply
Roll
Take-up
Roll
Retransfer
Ribbon Carrier
Supply Roll
Take-up Roll
Latch 3
Latch 2
Latch 1