Rimage Everest 600, Руководство пользователя

Страница: 6 / 217

3
Important Information
For more information visit rimage.com/support 2001474_B
Safety and Compliance Information
This manual and the indications on the product allow proper and safe
operation. The indication marks below help protect you and other persons
from injury, and equipment from damage.
Refer to the
Safety Precautions
section on page 3 and the
Compliance
Information section on page 4 for more information.
Safety Precautions
To ensure safety, read these precautions and familiarize yourself with their
meaning before using the equipment.
n
Warning!
• Use of controls or adjustments or performance of procedures
other than those specified herein may result in hazardous radiant
exposure.
• Do not disassemble or use tools on the printer. All service procedures
should be performed by a Rimage-authorized technician, or sent in
for Rimage-authorized repair.
• Do not service the printer with the power cord plugged in the AC
outlet.
• The interior of the printer contains sharp edges.
• The front bezel of the printer can be opened by hand. Do not insert
your fingers.
• Do not touch the heat roller.
n
Country-specific cautions for Wideband Data Transmission systems:
2400-2483.5 MHz
• France: Do not use outdoors.
• Italy: If used outside of own premises, general authorization is
required.
• Norway: This subsection does not apply for the geographical area
within a radius of 20km from the center of NY-Alesund.
n
Caution:
• All equipment with AC line voltage, or low DC voltages, such as
switches, power supplies, fuses, fans, and non-stepper motors, must
be replaced with Rimage-approved components to maintain the
safety approval issued by UL.
• Use only the supplied AC power cord. Fore more information or to
order a new power cord, contact Rimage Customer Service.
• This product is designed for an office environment.
• Do not use the printer if it is overheating or an abnormal smell is
detected. This may result in a fire and an electric shock. In case of
heating or abnormal smell, immediately disconnect the cable from
the outlet. Contact your Rimage-authorized dealer for repairs.
• Allow sufficient free space for opening the printer tray. Do not touch
the printer tray while it is in motion.
• If the side cover is opened while power is supplied, the printer will
stop. Do not reach into the printer while it is in operation. Do not
attempt to bypass the door interlock.
• This printer has no power switch. Power is disconnected completely
by unplugging the cable. Rimage recommends installing the printer
in a position that allows immediate disconnection of the power
cable. Always hold the plug when disconnecting the cable from the
outlet.
• This printer has a voltage slide switch on the back of the unit. Before
use, check that is set to the correct voltage. Please do not use any
voltage other than 110VAC or 220VAC. This could result in a fire and
an electric shock.