DiscLab Family™
Operator
2000775_A
© 2007, Rimage Corporation
1
Replace the USB hub on a DL5200
Use this procedure to replace the USB hub on a
DL5200™
.
Rimage approved parts must be used for this process. The product warranty may become void if parts not approved by Rimage are
used; equipment or parts are tampered with, misused, neglected, or modified in any respect without the written consent of Rimage.
Before you begin
1. Stop or pause all jobs.
2. Power off the
external
control center
.
3. Power off the
DL5200
.
4. Disconnect
the
power cord
from the power outlet.
#
Required tools
:
•
Torx T10 screwdriver
•
Small Phillips screwdriver
Remove the USB hub
1. Disconnect
the
USB cable
from the back of the DL5200.
n
Caution! Some cables in this system are latched.
Equipment damage may occur if cables are not
disconnected appropriately.
2. Remove the left side panel.
a. Remove
the
Torx T10 screws
(Qty.8) securing the left side panel.
b. Remove
the
left side panel
.
USB cable
3. Disconnect the cables (Qty. 3) from the
USB hub.
•
USB cable
at P3
•
USB cable
at P2
•
Power cable
Left Side Panel
USB Cable at P2
USB Cable at P3
Power Cable
