14
ADJUSTMENTS
B
A
Figure 19
RAISING AND LOWERING THE TABLE
1. Loosen the column lock handle (Figure 19, A)
on the table support bracket (B).
2. Turn the crank handle (C) to raise or lower the
table to the desired height.
3. Tighten the column lock handle (A).
NOTE:
The table assembly can rotate 360
o
around the column by loosening the table lock
handle and turning the table to the desired
position. The column collar’s hex nut may have to
be loosened to allow the table assembly with the
rack to be rotated. Retighten the collar nut when
the table is in final position.
C
TILTING THE TABLE
1. Loosen the large bolt (#8A) below the table
support arm (Figure 20, A). This requires an
24mm (1”) socket or
adjustable wrench, not
included.
2. The small threaded pin with nut below the
large bolt (Figure 20, B) positions the table at 90°.
Tighten
the nut to withdraw the pin from its index
hole in the support frame so that the table can be
tilted from the pre-set 90° position.
3. Tilt the table to the desired angle using the tilt
scale and pointer on the bracket to indicate the
angle. (Figures 21 & 22).
4. Tighten the large bolt below the table support
arm to secure the table in the an
gled position.
5. To return the table to the original 90° setting,
reverse the steps listed above.
B
A
Figure 20
Figure 21
THE MACHINE MUST NOT BE
PLUGGED IN AND THE POWER SWITCH MUST BE IN THE
OFF POSITION UNTIL ALL ADJUSTMENTS ARE COMPLETE.
Figure 22
