Figure 13
Figure 14
12
ASSEMBLY
C
B
Figure 12
Figure 15
THE MACHINE MUST NOT
BE PLUGGED IN AND THE POWER SWITCH
MUST BE IN THE OFF POSITION UNTIL
ASSEMBLY IS COMPLETE.
INSTALLING THE TABLE
1. Install the large Locking Lever (#16A) onto the
rear joint of the table support bracket and tighten
the locking lever. (Figure 12).
2. Install the table raising/lowering crank Handle
(#4A) to the side shaft of the Table Support (#17A)
with a hex wrench. (Figure 13).
3. If not pre-installed at the factory, install the
small Locking Lever (#7A, Figure 14, A) onto the
front joint of the Table Support Bracket (#9A, B).
(Figure 14).
4. Insert the table post (C) into the table support
bracket (B) as shown in Figure 14. Tighten the
locking lever (A) to secure the table in position.
NOTE:
The table can rotate 360
o
by loosening
the table lock handle and turning to the desired
position.
A
ADJUSTMENTS
CHANGING SPINDLE SPEEDS
1. Turn off and disconnect the
power to the Drill Press.
2. Open the machine’s top belt cover.
3. Release the locking knobs (#1D) on the both
sides of drill press head. Release the tension on
the belt by swinging the tension lever (#3D) from
right to left (Figure 15).
CONTINUED ON NEXT PAGE
