ASSEMBLY
9
BASE AND COLUMN ASSEMBLY
1. Place the Base (Part #1, Figure 1, A) on a level floor
where the machine will be used. FIG. 1.
2. Attach the Column (#2 & 5, B) to the base using four
M10x25 hex Bolts (#4). Tighten all four bolts.
NOTE:
The column is shipped with the toothed Rack
(#6), Collar Rack (#7) and Table Arm Assembly (#10-18)
pre-assembled on the column. The column should be
positioned on the base with the table arm facing forward
with the rack to the right side of the column.
3. Check the Hex Screw (#3) on the side of the support
column (B), and the Hex Screw (#8) on the Collar Rack
(#7) to make sure that they are secure.
INSTALLING THE HANDLES & TABLE
1. Install the large Locking Lever Handle (#9) onto the
rear joint of the table support bracket. Slide the handle
through the un-threaded hole on the bracket casting.
The handle will engage the threading on the other
side of the hole in the casting, then tighten the locking
lever to secure the bracket in place on the column.
FIG. 2.
2. Install the table raising/lowering Crank Handle (#19)
to the side shaft of the Table Support (#10) with a hex
wrench. FIG. 3.
3. If not pre-installed at the factory, install the small
Locking Lever (#9, Fig. 4, A) onto the front joint of the
Table Support Bracket (#15, B). FIG. 4.
4. Insert the table's (#20) post (C) into the table
support bracket (B) as shown in Figure 4. Tighten the
locking lever (A) to secure the table in position.
FIG. 3
FIG. 1
FIG. 4
FIG. 2
THE MACHINE MUST NOT BE
PLUGGED IN AND THE POWER SWITCH MUST BE IN
THE OFF POSITION UNTIL ASSEMBLY IS COMPLETE.
B
A
B
A
C
NOTE:
Parts referenced throughout the manual
refer to the identification key numbers of the Parts
Diagrams and Parts Lists on pages 22 to 25.
CONTINUED ON THE NEXT PAGE
