CONTENTS OF PACKAGE
8
J. Crank Handle
K. Table Bracket Lever Handle
L. Table Arm Lever Handle
M. Hex Head Bolts (4)
N. Hex Wrenches - 3 & 4mm
O. Special Wrench - 19mm / 8 mm
P. Drift Wedge
Q. 16mm Wrench
R. Manual & Warranty Card (not shown)
INSTALLATION
LIST OF LOOSE PARTS
Tools Needed for Assembly
- Phillips Screwdriver
- 10mm, 16mm or
Adjustable Wrench
- Rubber Mallet or
Hammer & Block of Wood
A. Head Assembly
B. Base
C. Column Assembly
D. Table
E. 5/8” Chuck
F. Arbor JT3 - MT2
G. Chuck Key
H. Speed Handle
I. Drive Handles (3)
G
K
I
H
J
L
A
F
D
C
E
B
N
M
Q
O
P
1. When moving the Drill Press, hold
both the column and under the drill press base to
lift and move the machine. The drill press head with
motor is top heavy and must remain upright to avoid
tipping.
DO NOT use the plastic lid assembly at any time
to move the tool!
DO NOT move or carry the Drill Press with the
work table, chuck or operating handles, as this
may also damage the machine.
2. Secure the machine onto a solid stand, or bench,
that is located in an area that has ample space in
front and at both sides for working and moving work
pieces around the drill press.
3. For best power and safety, the machine should
be plugged directly into a dedicated grounded
electrical outlet that is within the supplied cord length
of the machine. The use of an extension cord is not
recommended.
4. Align the machine so that during use, any
projects, debris or kickback will not face aisles,
doorways, or other work areas that bystanders may
be in. Do not locate or use the machine in damp or
wet conditions.
5. Once in place in your shop, make sure that the
machine is level. Secure the machine to a bench or
stand, with lag screws or bolts (not supplied). This
will eliminate any tipping over of the drill press, and
reduce any possible vibration during use.
MOVING & INSTALLING THE DRILL PRESS
