Rikon Power Tools 20-110, Руководство пользователя

Страница: 11 / 26

11
Figure 14
45º Fence Adjustment
Note: Whenever making an adjustment to the fence lift the
fence up slightly after releasing the lock handle to avoid
scratching the table.
1. Loosen lock handle (B, Figure 14). Move the stop plate (F,
Figure 14) out of the way and position the fence at the 45
º
angle. Make sure the fence sits against the stop bolt (G,
Figure 14).
2. Place a combination square on the fence and table to
confirm a 45
º
angle setting.
3. To adjust, loosen lock nut and bolt (G, Figure 14), until a
45
º
angle is obtained, and tighten lock nut (G, Figure 14).
4. Tighten lock handle (B, Figure 14).
Depth Lock Handle
1. Attach depth lock handle. (A, Figure 15). This should
be attached before Depth Limiting Stop (B, Figure 15)
for easier installation.
Depth Limiting Stop
1. Attach depth limiting stop. (B, Figure 15).
3. Adjust the fence to a 90
º
angle by releasing lock handle
(B, Figure 14).
4. Place a combination square on the in-feed table to check
that the fence is 90
º
to the table.
5. If fence is not square to table, release lock handle (D,
Figure 14) and turn handle (C, Figure 14) until the fence
is 90
º
6. Now that the fence is 90
º
to the table, adjust the positive
stop screw assembly, (E, Figure 14) to maintain the 90
º
position. Te 14).
7. Retighten lock handle (D, Figure 14).
A
C
B
D
F
E
G
Figure 15
A
B
C
D