18
ADJUSTMENTS
TABLE ADJUSTMENTS
The infeed and outfeed tables are preset at the
factory to be aligned with the cutterhead. To ensure
that both tables are aligned, check both table settings
and adjust as necessary.
This procedure involves close
contact with the jointer knife inserts. Wear gloves to
prevent injury to the hands. Make sure that the
machine is disconnected from the power supply.
1. Remove rear door of the jointer stand.
2. Set the infeed table to the ‘0’ setting on its depth of
cut scale. FIG. 30.
4. Rotate the cutterhead so that the knife inserts are
at their highest point by pulling on the drive belt until
the desired position is set.
3. With a long metal straight edge, place it length-
wise along the outfeed table so that it extends onto
the insert cutter at its highest rotation point. Check the
measurement on the insert cutter to the far right and
then far left on the cutterhead. FIG. 31.
4. If the straight edge does not touch the insert
cutter(s), the outfeed table will need to be adjusted.
A. Release the locking lever (A) at the rear of the
outfeed table. FIG. 32.
B. Turn the handwheel (B) to adjust the outfeed table
until it is parallel with the edge of the cutter(s). FIG.
32.
NOTE:
Turning the handwheel clockwise will lift up
the table, turning counterclockwise will lower the
table.
C. Once the table is set, tighten the locking lever (A)
to secure the table in its new setting. FIG. 32.
THE MACHINE MUST NOT BE
PLUGGED IN AND THE POWER SWITCH MUST BE IN
THE OFF POSITION UNTIL ALL ADJUSTMENTS ARE
COMPLETE.
FIG. 31
FIG. 30
FIG. 32
CONTINUED ON PAGE 19
Set Infeed Table to “0”
Straight Edge
Outfeed Table
Check Insert
Clearance
A
B
