10
THE MACHINE MUST NOT BE PLUGGED IN AND THE POWER SWITCH
MUST BE IN THE 'OFF' POSITION UNTIL ASSEMBLY IS COMPLETE.
ASSEMBLY
FIG. 5
FIG. 6
FIG. 7
INSTALLING THE FENCE
Locate the Fence Mounting Bracket and four M8 x
45mm Allen bolts.
The Fence Mounting Bracket attaches over the cut-
terhead pulley at the rear of the jointer top.
1. Hold the Fence Mounting Bracket (A) over the
cutterhead pulley and align the mounting holes (B) to
the jointer base. FIG. 7.
Motor Mounting
Nuts (x4)
DRIVE BELT & PULLEY ALIGNMENT
The procedure below will ensure drive belt longevity
and reduce vibration. If the pulleys are not set cor-
rectly, excess wear to the belts and power transfer
may be reduced.
1. Loosen the four 13mm motor mounting nuts holding
the motor onto the inner slide rail. Fig. 5.
2. Using a straight edge (Fig. 6.) align the face of the
cutterhead pulley to the motor pulley by sliding the
motor in the appropriate direction.
3. After the pulleys are properly aligned, tighten the
four 13mm motor mounting nuts holding the motor
onto the inner slide rail. Fig. 5.
4. Install the rear door of the jointer stand which was
removed in section “Jointer Top Assembly”, page 9.
CONTINUED ON PAGE 11
A
B
