Rikon Power Tools 10-341, Руководство оператора

Страница: 15 / 36

15
ADJUSTING THE DRIVE BELT TENSION
Check the Drive Belt (#79, FIG. 19, A) tension with
thumb pressure. The drive belt should not give more
than 3/8” in the center. FIG. 20. To adjust the tension:
1. From the rear of the machine, loosen the two Hex
Nuts (#65, B) that secure the motor to the frame.
2. Loosen the Hex Nut on the top of the Motor Pulling
Rod (#68, FIG 19, C). The motor should now be loose
enough to move downward for adjusting the belt.
3. For less tension on the drive belt, push the motor
downward.
4. For more tension on the drive belt, lift the motor
upwards. NOTE: There is a second hex nut on the
motor pulling rod that is located under the frame. This
second hex nut must be loosened to allow the motor to
be lifted upwards.
5. When the belt tension is correct, tighten all the motor
mounting nuts that were done in steps 1, 2 and 4.
See page 20 for instructions on replacing the Drive Belt.
FIG. 20
A
B
FIG. 19
ADJUSTMENTS
ADJUSTING THE RIP FENCE FOR DRIFT
Align the fence assembly, in or out, until it is parallel
with the side of the blade and miter gauge slot.
1. Loosen the two Hex Bolts (#166, FIG. 21, A) that
connect the Rip Fence (B) to the Fence Carrier (C).
2. Adjust the Fence parallel with the side of the blade
and miter gauge slot. Use a ruler for this (E).
3. Re-tighten the two hex bolts to secure the fence in
postion.
ADJUSTING THE FENCE 90° TO THE TABLE
Check that the fence is 90 degrees to the table using a
square. If an adjustment is required:
1. Slightly loosen the two Hex Bolts (A) that connect
the Rip Fence to the Fence Carrier (#172, C).
2. Adjust the Set Screws (#170, D) in the Rail Plate
(#180) to tilt the fence until it is 90 degrees to the table.
3. Once set at 90 degrees, re-tighten the two hex bolts.
FIG. 21
THE MACHINE MUST NOT BE
PLUGGED IN AND THE POWER SWITCH MUST BE
IN THE OFF POSITION UNTIL ALL ADJUSTMENTS
ARE COMPLETE.
BELT DEFLECTION
B
C
A
B
C
A
A
D
90°
90°
END VIEW
TOP VIEW
C
D
D
E