11
ASSEMBLY
FIGURE 5
INSTALL GUIDE RAIL FOR FENCE
1. Position the fence’s Guide Rail (#96) onto the front
table edge. The guide rail’s front lower edge, with 3 cut-out
areas, fits under the table. The center cut-out gives access
to the table leveling bolt and wing nut. The 2 outer cut-out
areas are where the guide rail will be fastened to the table.
2. Secure the guide rail to the table with the two Star Knob
Screws (#97). FIG. 5.
RIP FENCE ASSEMBLY
1. Install the Fence Carrier Assembly (#99-111) onto the
fence’s Guide Rail. The Carrier’s front, Lever Handle (#101)
should be lifted up, released, to allow the Carrier (#100)
to fit onto the top of the guide rail. Once in place, move
the carrier’s front lever handle down to lock the carrier in
position on the guide rail. FIG. 6 A.
2. The Fence (#106) attaches to the carrier by sliding it
onto the steel Locking Frame Bar (#105). FIG. 6 B.
There are two ‘T’ slots in the fence that the bar will slide
into. FIG. 6 V & H.
- Slot V is to use the fence in a
vertical
position.
- Slot H is to use the fence
horizontally.
3. Loosen the two Nuts (#110) on the left side of the carrier
to free the Locking Bar so that the fence can be easily slid
onto the bar. Once in place, secure the fence to the carrier
by tightening the same 2 nuts which pulls the locking bar
with attached fence back against the carrier.
See page 13 for Rip Fence Adjustments.
FIGURE 6
B
FENCE HOLDER ASSEMBLY
1. Install the Fence Storage Hanger Panel (#62) to
the top, left side of the column with two Phillips Screws
(#63). See Figure 7, which shows the proper positon of
the hanger’s top and bottom lips. The wider, double lip
should be at the top, the single lip at the bottom.
This hanger allows handy storage for the Rip Fence and
Carrier Assembly when not in use.
2. To use, just slide the fence & carrier onto the hanger
and lock it in place with the carrier’s lever handle.
3. Reverse the process to remove the fence from the
hanger.
BLADE TENSION HANDLE
1. Place the Blade Tensioning Handle (#20) onto the
Tension Rod end (#21) located at the top of the frame.
FIG. 8.
See page 14 for Blade Tensioning Adjustments.
FIGURE 8
BLADE
TENSION
KNOB
FIGURE 7
A
V
H
