RIKEN ON-5H-18, Руководство по эксплуатации и обслуживанию

Страница: 9 / 18

Tighten the high pressure hoses, couplers and other fittings
!
under rated torque of about 79 to 98 N m{8 to 10 kgf m} by
" "
use of vices.
Check if dusts are sticked to the threads or not.
!"#$%&' %$& ()# '*% +, %$& -+*./&01 2,+0 3456 76 89 -+:./&%&/;. =, '+%
%"#$%&'&> -+:./&%&/;6 %$& -;/"'>&01 >+ '+% +.&0)%& 1:++%$/;. =, %$& .*//
1">& -+*./&0 "1 '+% %"#$%&'&> -+:./&%&/;6 )1 %$& .0&11*0& +, %$& .*// 1">& "1 ) >+*(/& +, .*1$ 1">&6 %$&
-+*./&016 -;/"'>&016 )'> $+1&1 :"#$% (& >):)#&>6 )'> .&01+')/ "'?*0; :); $)..&'.
Match the dent part of the ring @AB45C B+*./&01 D
and the notch part of ROC-13H coupler, then pull
the ring to the notch side, and insert into ROC-
13R coupler completely, then release the ring.
The coupler will be locked automatically and
connected. Then, turn the ring to mismatch the
dent part of the ring and the notch part of ROC-
13H and to complete the connection. Check if the
coupler is connected correctly or not by pulling
ROC-13H coupler this side.
E9 F+G %+ B+''&-% (; *1& +, %$& F"#$ H0&11*0& 3%&&/ H".&1
See our General catalog or request us to send you an operation manual for the flareless fittings.
I. H0&.)0)%"+' (&,+0& A.&0)%"+'
259 F+G %+ 0&/&)1& %$& )"0 "' %$& .*:.
After you change oil, or when the pump sucks air due to lack of oil, air will be mingled into the oil. Then
the pressure will not increase or the cabitations may happen, and the cylinder will not operate smoothly.
Accordingly, release the air as follows.
(A) Open shut-off valve, and operate the pumps.
Shift air shut-off valve to STOP side and to START side by repeating operations 5 to 10 times.
(B) By the above procedures, the air will be released.
279 F+G %+ 0&/&)1& %$& )"0 "' %$& ."."'#1
If the air is included in the pipings, the cylinder will not operate smoothly. Release the air from the hoses
or steel pipes as follows.
The air releasing shall be proceeded to release the air outside, but not to retract
the air included oil to the reservoir. Accordingly, the oil in the reservoir will be
decreased. Feed oil as per Page 9. To change hydraulic working oil.
- 8 -
Bag nut
Clearance
Pull side
Push side
J++>
K+ #++>
Bag nut