7 Maintenance
7-2. Maintenance mode (Regular maintenance)
- 35 -
RP-D58 Series
7-2. Maintenance mode (Regular maintenance)
Mode Item
LED
display
Details
Maintenance
mode
(Regular
maintenance)
Test mode
2-0
Performs various tests.
2-0.2 Fault test
2-0.3 LED test
2-0.4 Memory test
Environmental setting
2-4
Used for various environmental settings.
2-4.8 Energized/de-energized contact setting
2-4.E Password setting
2-4.F Sensor fault alarm pattern setting
Electrical setting
display
2-5
Displays various electrical settings.
This is not typically used by the user.
Flow sensor setting
2-6
2-6.0 Flow sensor heater voltage adjustment
2-6.1 Flow rate zero point setting
2-6.2 Low flow rate threshold value setting
2-6.3 Flow sensor zero point check
2-6.4 Flow sensor output check
2-6.5 Pump output check
2-6.7 Flow sensor operation start setting
2-6.8 Low flow rate alarm delay time setting
2-6.9 Flow sensor function ON/OFF setting
Flow sensor various
setting display
2-7
Displays various settings of the flow sensor.
This is not typically used by the user.
Switches to factory
mode
2-8 Not
used.
Switches to user mode 2-9
Returns to the user mode.
PW
A
F
L
H
LED
User mode
In "1-3.", press the SET key.
◎
○ ○
● ○
1- 3
↓
↓
Then hold down the SET
key again for three seconds.
◎
○ ○ ● ○
‐‐‐‐
↓
↓
While the ESC key is
pressed, the LED displays
"....".
◎
○ ○ ● ○
‐
.
‐
.
‐
.
‐
.
↓
Regular
maintenance mode
WARNING
After the adjustment is completed, never fail to press MENU/ESC key to return to the detection
mode.
(If the detector head remains in the maintenance mode, it automatically returns to the detection
mode in ten hours.)
