6703 ZINSER ST., SCHOFIELD, WI 54476
PHONE: 800.298.4351 FAX: 866.882.9475
www.raproducts.com
VERSION DATED: 8/5/13
K&A MANUFACTURING
ITEM # PART #
DESCRIPTION
QTY.
A
51498 NewCrank CRANK HOLDER
1
B
51499 NewCrank CLAMP W/SCREW
2
C
52515 8-32x1/2 PHILLIPS FLAT HEAD THREAD CUTTING MACHINE SCREW
2
D
VARIES NewCrank HEX ROD/CRANK ASSEMBLY
1
PAGE 4 OF 4
TO CONVERT THE WORKSTATION FROM LEFT HANDED OPERATION TO RIGHT HANDED OPERATION FOLLOW THE
INSTRUCTIONS BELOW:
STEP 1:
LOOSEN THE SCREW IN THE CLAMP
B
CLOSEST TO THE LEFT HAND COLUMN. PULL THE HEX ROD/CRANK
ASSEMBLY OUT OF THE CRANK HOLDER
A
TOWARD THE FRONT AND SET IT ASIDE FOR INSTALLATION ON THE RIGHT
HAND COLUMN.
STEP 2:
REMOVE THE (2) SCREWS
C
ATTACHING THE CRANK HOLDER
A
TO THE WORKSURFACE SUPPORT.
STEP 3:
ATTACH THE CRANK HOLDER
A
TO THE WORKSURFACE SUPPORT ON THE RIGHT HAND COLUMN
ASSEMBLY. DO NOT OVER-TIGHTEN THE SCREWS. IT IS POSSIBLE TO CRACK THE CRANK HOLDER BASE. USE A
LOW TORQUE SETTING ON THE DRILL.
STEP 4:
INSERT THE HEX ROD/CRANK ASSEMBLY
D
THROUGH THE CRANK HOLDER
A
AND THE CLAMP
B
AND INTO THE HEX DRIVE AT THE FRONT OF THE COLUMN. INSERT IT UNTIL IT BOTTOMS OUT. YOU MAY NEED TO
TURN THE CRANK SLIGHTLY TO ALIGN THE HEX ROD WITH THE HEX DRIVE.
STEP 5:
SLIDE THE CLAMP
B
AGAINST THE CRANK HOLDER
A
AND TIGHTEN THE SCREW.
A
WORKSURFACE SUPPORT
C
HEX DRIVE
D
B
LEFT HAND COLUMN SHOWN
RIGHT HAND COLUMN IS SIMILAR
B
