6703 ZINSER ST., SCHOFIELD, WI 54476
PHONE: 800.298.4351 FAX: 866.882.9475
www.raproducts.com
VERSION DATED: 8/5/13
K&A MANUFACTURING
DETAIL A
1
STEPS 4 & 5
6
5
8
STEPS 6-9
PAGE 2 OF 4
STEP 4:
PLACE THE CENTER COLUMN ASSEMBLY
6
ON THE WORKSURFACE ALIGNING THE HOLES IN THE WORK-
SURFACE SUPPORT WITH THE PILOT HOLES IN THE WORKSURFACE. INSERT ONE OF THE (2) HEX RODS
8
INTO THE
HEX DRIVE NEAR THE TOP OF THE COLUMN ASSEMBLY. PLACE THE LEFT COLUMN ASSEMBLY
5
ON THE WORK-
SURFACE AND SLIDE IT TOWARD THE CENTER COLUMN ASSEMBLY INSERTING THE OTHER END OF THE HEX ROD
INTO THE HEX DRIVE NEAR THE TOP. YOU MAY NEED TO TURN THE CRANK SLIGHTLY TO ALIGN THE HEX ROD
WITH THE HEX DRIVE. ALIGN THE HOLES IN THE WORKSURFACE SUPPORT WITH THE PILOT HOLES IN THE WORK-
SURFACE.
STEP 5:
REPEAT
STEP 4
WITH THE OTHER HEX ROD
8
AND THE RIGHT COLUMN ASSEMBLY
7
.
STEP 6:
INSERT (2) SOCKET SCREWS
11
INTO (2) STAR WASHERS
10
. INSERT THESE THROUGH THE CENTER HOLES
IN THE SUPPORT BRACKET
9
AND THREAD THEM INTO THE T-SLOT PLATE THAT IS PRE-INSTALLED IN THE CENTER
COLUMN ASSEMBLY
6
. SEE DETAILS A AND B. TIGHTEN THE SOCKET SCREWS JUST ENOUGH SO THE SUPPORT
BRACKET CAN MOVE UP AND DOWN ON THE COLUMN ASSEMBLY.
STEP 7:
WITH THE HELP OF AN ASSISTANT, INSERT (4) SOCKET SCREWS
11
INTO (4) STAR WASHERS
10
. INSERT (2)
OF THESE THROUGH THE HOLES IN THE RIGHT HAND END OF THE CROSS SUPPORT
12
. THREAD THEM INTO THE
HOLES IN THE SUPPORT BRACKET
8
AND FULLY TIGHTEN. INSERT THE OTHER SOCKET SCREWS WITH WASHERS
THROUGH THE HOLES IN THE LEFT HAND END OF THE CROSS SUPPORT. THREAD THEM INTO THE HOLES IN THE
T-SLOT PLATE IN THE LEFT HAND COLUMN ASSEMBLY
5
. SEE DETAIL A. DO NOT FULLY TIGHTEN.
5
6
12
7
PRE-INSTALLED
T-SLOT PLATE
12
9
10
6
11
13
DETAIL B
