PAGE 1 OF 4
VERSION DATED: 8/5/13
TOOLS REQUIRED FOR ASSEMBLY:
CORDLESS DRILL
#2 PHILLIPS HEAD DRIVER BIT OR
#2 SQUARE HEAD DRIVER BIT
7/32" HEX HEAD DRIVER BIT OR
ALLEN WRENCH (PROVIDED)
TAPE MEASURE
LEVEL
NewCrank 3-LEG™ CRANK HEIGHT ADJUSTABLE WORKSTATION ASSEMBLY
INSTRUCTIONS:
STEP 1:
LAY THE WORKSURFACE(S)
1
ON A PROTECTED SURFACE WITH THE
PILOT HOLES FACING UP. IF YOUR WORKSTATION HAS U-CHANNEL(S)
2
AND/
OR JOINER PLATE(S)
3
, ATTACH THEM AS FOLLOWS. IF NOT, PROCEED TO
STEP 4
.
STEP 2:
U-CHANNELS
2
ARE INCLUDED ON 72" AND LARGER WORKSTATIONS.
ALIGN THE HOLES IN THE U-CHANNEL(S) WITH THE PILOT HOLES IN THE WORK-
SURFACE(S)
1
. ATTACH THE U-CHANNEL(S) TO THE WORKSURFACE(S) WITH
(10) WOOD SCREWS
4
ON THE 42" U-CHANNEL OR (12) WOOD SCREWS ON
THE 54" U-CHANNEL. DO NOT OVER-TIGHTEN THE SCREWS. USE A LOW
TORQUE SETTING ON THE DRILL.
STEP 3:
CENTER THE JOINER PLATE(S)
3
ON THE SEAM BETWEEN THE WORK-
SURFACES AND 3" FROM THE EDGES OF THE WORKSURFACES
1
. NO PILOT
HOLES ARE PROVIDED FOR THE JOINER PLATE(S). ATTACH THEM TO THE WORK-
SURFACES WITH (8) WOOD SCREWS
4
IN EACH JOINER PLATE.
INSTRUCTION # 52635
HARDWARE PACK # 52226 PLUS CENTER LEG BRACKET HARDWARE
ITEM # PART #
DESCRIPTION
QTY.
1
VARIES WORKSURFACE(S)
VARIES
2
VARIES 42" OR 54" U-CHANNEL
VARIES
3
35UP 3x5 WORKSURFACE JOINER PLATE
VARIES
4
51708 M5 x 18mm SQ/PH/WSHR HEAD WOOD SCREW VARIES
5
VARIES NewCrank COLUMN ASSY LH
1
6
VARIES NewCrank COLUMN ASSY 12" 3-LEGGED CENTER
1
7
VARIES NewCrank COLUMN ASSY RH
1
8
VARIES NewCrank HEX ROD
2
9
VARIES NewHeights 3-LEG CROSS SUPPORT BRACKET
1
10
52477 3/8 INTERIOR TOOTH STAR WASHER
10
11
52470 3/8-16 x 3/8 BUTTON HEAD SOCKET SCREW
10
12
VARIES NewHeightsCROSS SUPPORT 3-LEG
2
13
800411 NewHeights/HOVER END CAP
4
14
52498 7/32" ALLEN WRENCH
1
YOU MAY HAVE (2) JOINER PLATES.
4
READ ALL THE INSTRUCTIONS BEFORE BEGINNING.
DO NOT OPERATE THE UNIT UNTIL IT IS FULLY ASSEMBLED.
1
2
3
4
4
STEPS 1-3
6703 ZINSER ST., SCHOFIELD, WI 54476
PHONE: 800.298.4351 FAX: 866.882.9475
www.raproducts.com
K&A MANUFACTURING
