Page 9 OF 9
K&A Manufacturing
6703 Zinser Street Schofield, WI 54476
Phone: 800.298.4351
Fax: 866.882.9475
www.raproducts.com
ITEM # PART #
DESCRIPTION
QTY.
A
Varies Track Assembly
1
B
52336 3/16" Aluminum Rivet Washer .198 x .510 x .067
2
C
52678 8-18X1/2 Phillips Pan Self Drill Screw
2
D
51708 M5 x 18mm (7/8") Sq/Ph/Wshr Head Wood Screw
2
E
Varies LT U-channel
1
Instruction # 53026
Instructions to Install a Track on a Series 4 LT Workstation:
Step 1:
Place the front of the track
A
against the bottom of the worksurface and place
the back of the track on the angled part of the U-Channel
E
.
Step 2:
Align the holes in the track
A
with one set of pilot holes in the u-channel
E
keeping the front of the track 1/8"-5/8" from the front of the worksurface. Place (2)
washers
B
on (2) self drilling screws
C
. Drive them through the track and into the
u-channel.
Step 3:
Attach the front of the track
A
to the worksurface using (2) wood screws
D
. Do
not over-tighten the wood screws. Use a low torque setting on the power driver.
Step 4:
Complete the installation using the instructions that came with the product you
are installing.
Step 12:
Raise the leg assemblies high enough to fully
tighten the motor screws
6
. Fully tighten the screws and
return the leg assemblies to their lowest position. With
the help of an assistant, set the workstation upright in its
final position. Level the workstation if required by turning
the leveling glides clockwise (from the top) on the low
corners of the unit. If your workstation has casters, level it by turning the bolts at the top
of the casters.
A
B
C
D
E
Your worksurface may
be different than the
one shown here.
Side View
(Track will be at
an angle when
installation is finished.)
A
E
