Page 5 OF 9
K&A Manufacturing
6703 Zinser Street Schofield, WI 54476
Phone: 800.298.4351
Fax: 866.882.9475
www.raproducts.com
Step 4:
Place the right leg assembly
4
(Leg B)
on the worksurface
1
. Insert the end of the hex
rod
3
into the hex drive on the right leg assembly.
You may need to turn the hex rod clockwise
slightly with an adjustable wrench to align the hex
rod with the hex drive in the right leg assembly.
It should take no more than 1/6th of a turn to
accomplish this. If you turn it more than 1/6th of
a turn, the legs will be at different heights and
the worksurface won't be level.
If your worksurface does not have pilot
holes, skip Step 5. Go to Step 6.
Step 5:
Align all the holes in the worksurface
supports with the pilot holes in the worksurface.
Attach the leg assemblies to the worksurface
with (8) wood screws
13
in each leg assembly.
Leave the screws loose by about 1/8" until
after the cross support
8
is installed.
Step 6 applies to worksurfaces with no
pilot holes.
Step 6:
Square and align the worksurface
supports as shown in the bottom and the side
views below. Worksurface supports must be
parallel to the edges of the worksurface.
Attach the leg assemblies to the worksurface
with (8) wood screws
12
in each leg assembly.
Leave the screws loose by about 1/8" until
after the cross support
8
is installed.
Instruction # 53026
Step 4
Dimensions A Must Be Equal
Step 6
Side View
.300 For 24"Deep
3.438 for 30" Deep
Step 6
Bottom View
Dim A
Dim A
Step 5
Worksurface
Support
12
3
4
1
Leg B
