PAGE 3 OF 3
IF YOUR CPU IS LESS THAN 3 7/8" WIDE FOLLOW THE STEPS BELOW:
STEP A:
REMOVE THE BUCKLES FROM THE FREE ENDS OF THE STRAPS ON THE CPU HOLDER,
THEN REMOVE THE STRAPS FROM THE CPU HOLDER.
STEP B:
RE-ROUTE THE FREE ENDS OF THE STRAPS THROUGH THE SLOTS IN THE TOP OF THE
CPU HOLDER AS SHOWN ON THE FRONT VIEW. RUN THE FREE ENDS UP THROUGH THE RIGHT
HAND SLOTS FROM THE BOTTOM. THEN RUN THE FREE ENDS BACK DOWN THROUGH THE
LEFT HAND SLOTS FROM THE TOP.
STEP C:
RE-ATTACH THE BUCKLES TO THE STRAPS. THE BACK OF THE BUCKLES MUST FACE
THE CPU. RUN THE FREE ENDS OF THE STRAPS INTO THE BUCKLES FROM THE BACK. THEN
RUN THE FREE ENDS BACK THROUGH THE BUCKLES OVER THE TOPS OF THE LOCKING BARS.
THE FREE ENDS MUST FACE OUT FROM THE CPU HOLDER. GO BACK AND COMPLETE STEPS 6-8.
VERSION DATED 8/15/11
6703 ZINSER ST., SCHOFIELD, WI 54476
PHONE: 800.298.4351 FAX: 866.882.9475
www.raproducts.com
K&A MANUFACTURING
FRONT VIEW
FREE ENDS
ROUTE THE FREE ENDS UP THROUGH THE
RIGHT HAND SLOTS, THEN DOWN
THROUGH THE LEFT HAND SLOTS.
RUN THE FREE ENDS UP THROUGH THE BUCKLES
FROM THE BACKS. THEN RUN THEM BACK
DOWN OVER THE TOPS OF THE LOCKING
BARS & THROUGH THE BUCKLES. THE FREE
ENDS SHOULD FACE OUT FROM THE CPU
HOLDER.
FREE END
