Right Weigh 201-EBT-04B, Руководство по установке и эксплуатации

Страница: 17 / 24

TROUBLESHOOTING
17
Scale Does Not Power
On
Scale is not connected to a
switched power source of
between 9 and 32 VDC
Connect the scale to a switched power source between 9 and 32
VDC (typically either the vehicle marker lights or the AUX/ABS
wire). If there is a bad connection in the circuit which causes
voltage to drop below 9 volts, the scale will not power on. Test the
power source with a voltmeter.
Scale is connected directly
to the battery
Connect the scale to a switched power source between 9 and 32
VDC (typically either the vehicle marker lights or the AUX/ABS
wire). The scale is active anytime it is connected to power, even if
the display is off. To reset it, disconnect and reconnect to the
power source, wait 10 seconds, then try again to turn the display
on.
Polarity is incorrect
Correct the polarity. The red wire must be connected to positive
and the black to negative.
Cannot Change
Calibration Data
The scale has an active
user-defined security PIN
code
If the scale is protected with a PIN code, the PIN must be entered
before calibration data can be changed. To understand how to
reset the PIN code, see page 16. If the PIN code has been
forgotten, please call Right Weigh technical support listed on
page 2 for further assistance.
PROBLEM
CAUSE
SOLUTION