Restarting this mode is possible by pressing any key except
key.
After successful measurement in
Multé mode
, the following information will be displayed on the analyzer
screen:
band
number of stars (out of 5)
minimum value of SWR and the frequency at which this value was found
If there are more than one results detected by the analyzer, then the screens are switched using
the
keys.
When you press the
keys on one of the results screens, the analyzer switches to
HAM mode
on
the same band.
A long press of the
key will bring up the
Help menu.
HAM mode.
This mode allows you to measure and display the SWR antenna chart on the analyzer screen on one of the
fixed HAM radio bands such as:
2.2 km, 630 m, 160 m, 80 m, 60 m, 40 m, 30 m, 20 m, 17 m, 15 m, 12 m, 11 m, 10 m, 6 m, 2 m.
Enabling this mode is possible either from the main menu by pressing the
key or when the analyzer is
off by a long press of the same key. The measurement will be performed automatically in the range that was
used in the previous measurement.
To repeat the measurement, press
once. To measure in a cycle, press the
key two times at short
intervals. A long press of the
key will bring up the
Help
window.
You can change the measuring range using the
keys.
