11
Large Supine Stander mainboard
(E430)
Adjusting the mainboard:
The hand crank (A) controls transfer
height adjustment and the tilt angle of the
mainboard. By turning the crank, the board
in its horizontal position will move vertically
from 21" to 30"(53cm to 76cm) and then
begin to tilt. Continue to turn the hand
crank until desired angle is reached (see
Figure 11a).
Tilt angle is indicated on the board angle
label (B). This can be used to record the
correct angle setting for each user.
Attaching laterals:
Laterals (B) ship in reverse position.
To reposition laterals:
• Loosen knobs (C) and slide laterals out
from under the clamp.
• Rotate laterals into correct position and
replace them under the clamp.
• Tighten knobs (see Figure 11c).
Use knobs (C) to adjust the laterals laterally
and vertically.
Adjusting laterals and straps:
Any lateral or strap can be adjusted in
and out, or up and down. Loosen the two
knobs on the appropriate clamp, slide
lateral or strap to the desired position, and
tighten knobs securely.
To completely remove a lateral or strap,
loosen clamp knobs enough to slide
bracket out past the safety dimples (D).
The lateral or strap can then be moved to
a different set of clamps and the knobs
tightened securely (see Figure 11c).
Figure 11a
Figure 11b
C
C
B
B
A
A
D
D
Figure 11c
B
B
